HairGear
Products
31882 Del Obisbo #150
San
Juan Capistrano, Ca 92675
1-800-977-5444
 |
Follow
the easy steps…
Step 1.
|
 |
Step
2. Each strand of hair to be highlighted is separated and should remain free. To do this, comb through a section of hair to remain untreated. Take a ColoRod and roll this untreated hair three-quarters of an inch from the scalp, place a water-resistant paper on top of the ColoRod, and finish rolling. |
 |
Step
3. Now place the cover on the rod, and gently snap it in place. (Note: The special water-resistant paper is applied at the final turn. The lip-like edge on each side of the cover should be uniform.) The cover forms a seal on the hair around the rod. Next, place the desired amount of hair to highlighted over this wrapped rod, out of the way. Pick up the next section of hair to be wrapped and roll as before. |
 |
Step
4. When you have finished wrapping your custom highlight, all the untreated hair will be wrapped and all the strands to be highlighted remain free and ready to be colored or bleached. Beginning at the crown of the head, apply your color with a brush. Applications to the strands should be made one-eighth of an inch away from the scalp. Once you have completed your color application, you may choose to either cover the hair with a plastic bag, seat your client under the dryer, or leave the hair uncovered. |
 |
Step
5. As the color activates, it’s easy to select the desired shade of tone, and your client can watch the coloring process with you. Once you achieve your desired shade, rinse the color off. If the desired color is too light or toner is needed, you may apply now. The ColoRods may now be easily removed. Insert a rattail comb between the rod and cover, press down gently with the tip of the comb’s tail, while gently lifting upward to remove the cover. Then remove the ColoRods. |
 |
Step 6. |
HairGear
Products
31882 Del Obisbo #150
San
Juan Capistrano, Ca 92675
1-800-977-5444
©2000 ColoRods
& Cyberlive,Inc.
Site Designed, Hosted & Maintained by CyberLive,
Inc.
